Upfront Septic responded to a service call in Tacoma, WA, after a homeowner reported that their septic alarm was going off. The customer was concerned that the entire septic system was full and requested service to determine what was causing the alarm and whether the tanks needed to be pumped.
Upon arrival, our technicians located a two-compartment concrete septic tank and a separate pump tank in the backyard. Both tanks were equipped with risers, and the septic tank was approximately 10 inches below grade. During the inspection, the inlet and outlet baffles appeared to be in good condition. Our team also found no visible signs of major deterioration in the concrete tank floors or walls.
The primary concern was the pump tank alarm. Our technicians opened the pump tank and tested the alarm, confirming that it sounded as expected. We then tested the pump float, but the pump did not activate, even though the control panel lights turned on. To further troubleshoot the issue, our team switched the pump into hand mode. The pump still failed to operate, indicating that the problem was likely with the pump itself rather than the alarm or control panel.
Because both tanks required service, our technicians pumped approximately 1,000 gallons from the pump tank and another 1,000 gallons from the septic tank, for a total of 2,000 gallons removed.
Based on the troubleshooting results, the septic pump needs to be replaced. The recommended follow-up work includes installing a replacement pump and connecting it with 2-inch PVC pipe. Completing this repair will address the non-operational pump and help restore proper wastewater transfer from the pump tank. Upfront Septic provides septic pumping, alarm troubleshooting, and pump replacement services in Tacoma and surrounding Pierce County communities.
Project Gallery










